User Guide

INSTALLING THE BIG LINE KIT
5. If required, cut the open end of the hose assembly to the desired length and install the
½” push lock x -8 swivel (part# 4A-1-09-08-08-B) into the end. See Figures 12 & 13
Figure 12 Figure 13
Lubricate the fitting with oil. Push the hose completely on the barb.
6. Loosely install the male end of the 90° elbow (part# 4A-2-04-08-08-S) on the hose
assembly.
7. Route the hose assembly in a fashion to prevent kinking or chaffing.
8. Loosely install the female end of the 90° to the outlet fitting of the fuel filter canister
previously installed in step 3.
9. Tighten the connections that were left loose in steps 8 and 9.
Connect the factory power lead to the lead from the motor of the FRRP-150.