User Guide

INSTALLING THE FRRP-150 CONTINUED
7. Cut the open end of the “Output Hose Assembly” to the desired length and install the ½”
push lock x -8 swivel (part# 4A-1-09-08-08-B) into the end. See Figures 6 & 7
Figure 6 Figure 7
Lubricate the fitting with oil. Push the hose completely on the barb.
8. Loosely install the male end of the 90° elbow (part# 4A-2-04-08-08-S) on the hose
assembly.
9. Loosely install the female end of the 90° to the outlet fitting of the FRRP previously
installed in step 3.
10. Route the hose assembly in a fashion to prevent kinking or chaffing.
11. Tighten the connections that were left loose in steps 8 and 9.
12. Connect the factory power lead to the lead from the motor of the FRRP-100.