User Guide

INSTALLING THE BIG LINE KIT
1. Remove and discard the fuel hard line that runs between the filter canister and the
injection pump.
2. Install the seal washer and “WAP 102” male quick connect to the inlet port of the
injection pump. (See Figure 8)
Figure 8
3. Install the 12mm X -8 male JIC fitting with seal washer into the outlet port of the fuel
filter canister.
Figure 9 Figure 10
4. Install the female quick connect end of the hose assembly, WAP122-8-90, onto
WAP 102 installed in step 2 of this section. Push firmly until a “click” is heard.
Figure 11
WAP 102 and
Seal Washer
Outlet Port