Owners manual

ManualsBrandsAireman Filtration ManualsAppliances16x20x1 Electronic Air Filter - Homeowner Installed- Simply Replace Your Current AC Furnace Air Filter and PLUG IT IN!

R060216

Aireman Filtration, LLC.

www.Aireman.com

Electronic Air Filter – Installation, Operating and

Maintenance Instructions

Contents:

Shipping and Handling Damage Check

 1 - Filter – Inspect the screen and frame for any visual damage.

 1 - Class II transformer (120 vac - 24 vac)

 Replacement media pads

 1 - Filter opening tool (magnetic)

 1 - Filter media pad change sticker

Wingman1 Air Filter

Replacement Pads

Transformer Power Supply

Opening tool/key (magnetic)

Summary of content (4 pages)

PAGE 1
R060216 Aireman Filtration, LLC. www.Aireman.com Electronic Air Filter – Installation, Operating and Maintenance Instructions Contents: Shipping and Handling Damage Check      1 - Filter – Inspect the screen and frame for any visual damage.
PAGE 2
R060216 Installation NOTE For proper operation, standard conventions of filter location within the air system apply to the installation of the electronic filter. Do not install downstream of humidification equipment. Some arcing may occur during initial power-up but should cease after 10 seconds CAUTION NEVER energize the electronic filter with the filter open. ALWAYS unplug the filter at the jack on the filter power head before opening the electronic filter.
PAGE 3
R060216 7 – PUSH the electronic filter all the way into the filter rack. 8 – CONFIRM that the 24 vac power lead wire is not being pinched or in a position to be damaged by any cover that may exist. The cover may need to be modified and electrical tape can be wrapped around the power supply cord to protect it from damage. 9 – TURN the power ON at the air handler. 10 - RETURN the thermostat to the As Found position.
PAGE 4
R060216 5- Insert the provided filter opener/key at the “Open Here” locations along the frame that are opposite the hinged side of the filter frame. Inserting it closer to the corners will ensure the frame will not be bent during opening. Rotate the tool and the frame will separate easily. Perform the same at the other corner locking tab closure. 6- Remove old media and NOTE the orientation of the center screen. 7- Install new filter media on the power head side.