Instructions / Assembly

ManualsBrandsAireRyder ManualsOtherDynasty 4-Light Forum Patina Ceiling Fan Light Kit

Fig.1

Motor

Switch Box

White Wire

Ridged Wire

Hex Nut

Screw

Switch Box Cover

Nipple

Light Kit

Wire Nut

Smooth Wire

Washer

Center Plug

Black(Blue Wire)

Fig.3

Motor

Glass Holder

Glass Shade

Socket Ring

Pull Chain

For Light Kit:

DY-LKD004 --- Page 1

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless

additional support is provided for the fan.

DY-LKD004

070418

1. Remove the switch box cover from the switch

box of the fan by loosing the three screws.

2. Unscrew the center plug from the switch box

cover and discard it.

3. For fan style that is shown in Fig.1: Attach the

nipple of the light kit to the hole of the switch

box cover, then thread the wires through the washer and hex nut, then secure them tightly.

4. For fan style that is shown in Fig.2: Thread the fixture wire through the switch box cover.

Then attach the cap to the switch box cover, then secure it with two set screws (6x32 20mmL).

5. Pull out the wires from the switch box. Make wire connections using the wire nuts:

---The smooth (marked) wire from the light kit to the black or blue wire from the fan.

---The ridged (unmarked) wire from the light kit to the white wire from the fan.

---Carefully tuck wires back into the switch box.

6. Restore the switch box cover back to the switch box using the three screws.

7. Attach the glass shades to glass holders, then secure them with socket rings. (See Fig.3)

8. Install bulbs (not included). See relamping label at socket area or packaging for maximum

allowed wattage.

9. Turn on the power at the main fuse or circuit breaker box.

(You can control the lights with the pull chain.)



Nipple

(6 x 32 20mmL)

Set Screw

Fig.2

Screw

Black or Blue Wire

Wire Nut

Black

Motor

Switch Box

White Wire

Terminal (Groove)

Terminal ( Tongue)

White Wire

Switch Box Cover

Cap

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS DY-LKD004 WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless additional support is provided for the fan. Fig.
PAGE 2
For Chandelier: Fig.3 Fig.4 Loop Grounding Pad Washer Hex Nut Nipple(-b) Light Kit Loop Light Kit Outlet Box House Grounding Wire Wire Nut Hex Nut Washer Mounting Strap Green Grounding Screw Mounting Screw Nipple(-a) 1. Attach nipple(-a) to the mounting strap, then secure it with a washer and hex nut. 2. Attach the mounting strap to the outlet box by using two mounting screws. 3. Take out the cap from the hardware package for the chandelier. Canopy 4.