Instructions / Assembly

Tighten the hanger bracket to the
outlet box with 2 mounting screws.
(To reduce the risk of fire electric
shock, or personal injury, mount to
the outlet box marked acceptable for
fan support and use mounting screws
provided with the outlet box.)
FOR CEILING MOUNT:
Attach the canopy to the housing with
ceiling mount screws.
FOR DOWNROD MOUNT:
Insert the motor wires through the
canopy and downrod.
Turn off the electric power
PAGE: 1 / 3
WARNING :
TO AVOID RISK OF ELECTRICAL SHOCK. BE SURE TO SHUT OFF POWR WHILE
INSTALLING OR SERVING THIS FIXTURE.
NOTE:1. To ensure the success of the installation, be sure to read these instructions and
review the diagrams thoroughly before beginning.
2. All electrical connections must be in accordance with local codes, ordinances, and
National Electric Code. If you are not unfamiliar with methods of installing with
electrical wiring, secure the services of a qualified licensed electrician.
3. Total fan with light kit weigh ( FN44125--6.90 KGS/15 LBS FN52125--8.8KGS/19 LBS).
When using an existing outlet box, be sure the box is securely attached to the building
structure and can support the full weight of the fan. Failure to do so can result in serious
injury or death.
4. Before starting the installation, disconnect the power by turning off the circuit breaker
or by removing the appropriate fuse at the fuse box. Turning the power off by using
the light switch is not sufficient to prevent electrical shock.
Installation Steps :
FOR DOWNROD MOUNT:
Insert the hanger pin through the
holes in the collar and downrod.
Insert the lock pin through the hole
near the end of the hanger pin until
it snaps into its locked position.
Tighten downrod screws on top of
the fan motor finally.
FOR DOWNROD MOUNT:
Hang the fan on hanger bracket, and
make sure the slot of hanger ball is
into the chip of hanger bracket exactly.
Slot
Chip
Fig.1.
Fig.2.
Fig.6.
Fig.4.
Fig.3.
Fig.5.
Model No.: # FN 44125 FN52125
ASSEMBLY AND INSTALLATION
INSTRUCTIONS