Instructions / Assembly

PAGE: 2 / 3
060223
TM
Blue
Green ( Ground )
Fig.10.
Step 10 (for downrod & ceiling mount):
Make wires connection:
Measure the length of wire that you need.
1). The motor white wire to the white wire from the outlet box with a wire nut.
2). The motor black wire and blue wire to the black wire from the outlet box with
a wire nut.
3). The ground wire from the outlet box to the ground wire from the motor
with a wire nut.
*** After making the wire connections, the wires should be spread apart with the
grounded conductor and the equipment-grounding conductor on one side and
the underground conductor on the other side of the outlet box.
*** After the splices have been made, they should be turned upward and pushed
carefully up into the outlet box.
Step 9: Hang the fan on hanger bracket, and
make sure the slot of hanger ball is snapped
into the chip of hanger bracket exactly.
Fig.9
Chip
Slot
Step 14: Secure the switch box cover
upward to the switch box with the switch
box screws.
Fig.14.
Fig.12.
Step 12: Tighten blades to blade holders
by using blade screws and washers.
Step 11: Attach the canopy to the hanger
bracket, then secure it with four screws
and washers.
Blade Screw
Washer
Blade
Blade Holder
Fig.11.
Plastic
Insert
Switch Box
NOTE:
Before installing blade holders
to the motor, please remove the
plastic inserts. (See Fig.11)
Step 13: Secure blade holders to the
motor with motor screws and washers.
Fig.13.
Fig.15.
Step 15: Turn on the electric power at
the main fuse or circuit breaker box.
Use pull chain to control the fan speed.