Instructions / Assembly

Connect the two terminals respectively
from the motor and the switch box.
Blue
Green ( Ground )
Fig.9.
Make wires connection:
1). The motor white wire to the white wire from the outlet box with a wire nut.
2). The motor black wire and blue wire to the black wire from the outlet box with
a wire nut.
3). The ground wire from the outlet box to the ground wire from the motor with a
wire nut.
*** After making the wire connections, the wires should be spread apart with the
grounded conductor and the equipment-grounding conductor on one side and
the underground conductor on the other side of the outlet box.
*** After the splices have been made, they should be turned upward and pushed
carefully up into the outlet box.
PAGE: 2 / 3
Fig.11.
Tighten the blades to the blade holders
by using the blade screws and washers.
NOTE:
Before installing blade holders
to the motor, please remove the
plastic inserts.(See Fig.10)
Attach the canopy to the hanger
bracket and secure it with four
screws and washers.
Blade Screw
Washer
Blade
Blade Holder
Secure the blade holders to the motor
with the motor screws and washers.
Fig.10.
Plastic
insert
Fig.12.
Fig.13.
Switch Box
Secure the switch box with the set
screws.
Pull Chain
Switch Box
Set Screw
Fig.14.
060220
TM
Fig.15.
Turn on the electric power at the main
fuse or circuit breaker box. Use pull
chain to control the fan speed.