User's Manual

Mounting Airespace APs

After completing the steps in the Planning Airespace AP

Locations section, mount Airespace APs as follows. Refer to the

following figure for installation details.

Note: When mounting Airespace APs, make sure to

maintain a 20 cm (8 in.) separation between the Airespace APs and

any persons to comply with FCC RF exposure regulations. Refer to

the FCC Statements

section for more FCC information.

1 Collect the following supplies:

! Screwdrivers, drills, and ladder.

! An assortment of sheet metal and drywall screws and

toggle bolts.

! Airespace AP Vertical Mount Kits, one per Airespace AP

as required.

! Airespace AP Wall Mount Kits, one per Airespace AP as

required.

! CAT5 cables between the Airespace AP locations and the

planned Airespace Switch location.

2 Using the mounting kits supplied with each Airespace AP,

mount the Airespace AP in its final location. The following figure

shows the an Airespace AP and the ceiling mount. (Mounting

details to be determined.)

3 Mark the final mounting locations on the maps or

floorplans, including the "Front" direction, if the Airespace AP is

to be used with diversity disabled.

4 Copy the MAC Address(es) from the bottom of each

Airespace AP onto the maps or floorplans.

5 If the CAT5 cabling that will connect the Airespace APs to

the Airespace Switch is available, plug it into the Airespace AP

now.

Airespace AP and Ceiling Mount Assembly