Install Guide

3/18/03 Step 5: Verifying 802.11a Operation 13
Wireless Switch, and that its radios are transmitting their beacon
SSIDs.
• Using your 802.11a WiFi-approved device, verify that you can detect
the SSID “Airespace” and the MAC address from the label in the
802.11a Radio Card kit.
- If you detect the correct SSID and Mac address, the 802.11a
Radio Card is working properly; continue with the next proce-
dure.
- If you cannot detect the correct SSID and Mac address, the
802.11a card is not working properly; contact Airspace Technical
Support at 1-408-635-2000 for assistance.
• When you have verified that the 802.11a Radio Card is working
properly, remove power from the Airespace AP.
• Open the Airespace AP door.
• Move the Site Survey jumper onto either pin for future use.
You have successfully converted the 1200B into a 1200AB. Continue with
Step 6: Closing the Airespace AP Case.