Installation Manual

14 / 19
- Consultative Design-In - Proactive Supply Chain - Guaranteed Quality OEM / ODM
For corporate and sales, line-card, configurator and samples visit www.VOXMICRO.com
Regional offices in California (USA) – Oxfordshire (UK) – Hong Kong and Taiwan R.O.C.
AIRETOS
®
and OxfordTEC
®
are trademarked product brands of the VOXMICRO Group.
We Understand The Waves
module is installed must also display a label referring to the enclosed module. This exterior label can use wording such as the following:
“Contains IC: 20662-AEXQCA98X”.
Si le numéro de certification ISDE n'est pas visible lorsque le module est installé à l'intérieur d'un autre appareil, alors l'extérieur de l'appareil
dans lequel le module est installé doit également afficher une étiquette faisant référence au module inclus. Cette étiquette extérieure peut
utiliser un libellé comme celui-ci: “ Contient IC: 20662-AEXQCA98X“.
Plaque signalétique du produit final:
Le produit final doit être étiqueté dans un endroit visible avec l'inscription suivante: "Contient des IC: 20662-AEXQCA98X".
Manual Information to the End User:
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the
user’s manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as show in this manual.
Manuel d'information à l'utilisateur final
L'intégrateur OEM doit être conscient de ne pas fournir des informations à l'utilisateur final quant à la façon d'installer ou de supprimer ce
module RF dans le manuel de l'utilisateur du produit final qui intègre ce module. Le manuel de l'utilisateur final doit inclure toutes les
informations réglementaires requises et
avertissements comme indiqué dans ce manue
Must use the device only in host devices that meet the FCC RF exposure category, which means the device is installed and used at distances
of at least 30cm from persons.
The end user manual shall include FCC Part 15 /ISED RSS GEN compliance statements related to the transmitter as show in this manual.
Host manufacturer is responsible for compliance of the host system with module installed with all other applicable requirements for the
system such as Part 15 B, ICES 003.
Host manufacturer is strongly recommended to confirm compliance with FCC/ISED requirements for the transmitter when the module is
installed in the host.
Must have on the host device a label showing Contains FCC ID: 2AE3B-AEX-QCA98X, Contains IC: 20662-AEXQCA98X
The use condition limitations extend to professional users, then instructions must state that this information also extends to the host
manufacturer’s instruction manual.
If the end product will involve the Multiple simultaneously transmitting condition or different operational conditions for a stand-alone