User Manual

4
Guide for Airfree
®
installation in mold contaminated rooms
1 - Install your Airfree
®
unit in accordance with the user manual
2 - Allow your unit to run for at least one week to achieve signicant airborne mold spore reduction.
3 - Clean mold infected items and surfaces, since they are a continuous source of new spores.
It is important to stress that Airfree
®
will not destroy or remove mold from an infected item or surface. Those
surfaces must be cleaned manually.
Airfree
®
will destroy airbone molds, spores and prevents them from contaminating other areas, inhibiting the
growth of existing and new colonies.
Airfree
®
and Mold
Installing and Connecting
Plug power cord into the nearest outlet. Make sure the surface is dry (never place Airfree
®
on
wet oor or immerge it in water). Make sure side led light is on. Adjust the night light intensity
with the touch sensor. After 10 minutes the top lid should be warm.
Place Airfree
®
on a at surface not exceeding 3’ (75 cm) from the oor, not under furniture,
shelves, or behind curtains as it will reduce airow and Airfree
®
efciency in reducing
microorganisms.
Airfree
®
must be continuously on in the same room, 24 hours a day.
Airfree
®
is to be used in rooms with minimum air volume of 330 ft³ (10 m
³
).
Airfree
®
can be installed in rooms equipped with air conditioning and heating systems.
However it is recommended not to place it nearby to avoid potential interference in Airfree
®
air ow.
Airfree
®
can be placed in corridors but the air sterilization effects will barely have any effect
in connecting rooms.
Airfree
®
shall not be placed near doors or under windows to avoid sterilized air to exit the
room.
Check if the area is compatible with the unit capacity to achieve best unit performance.
To change night light intensity or to shut off, press the sensor on the top of Airfree´s logo. You
can choose the best light intensity or simply shut the lights off.