User's Manual

3 Installing the Access Point Using the Configuration Interfaces
30 Installation and User Guide: Airgo Access Point
Figure 16: Airgo AP Placement
Verifying the Installation
To verify the Airgo Access Point is operational, examine the front of the AP.
• Is the status LED red or green? If not, check the power connections and whether the AC outlet
has power.
• (For wired-AP installations) Is the Ethernet connection LED on? If not, check the Ethernet
cable to make sure it is seated securely in both the AP and the network port.
Interpreting the LEDs
Refer to Figure 17 and Table 8 for LED definition.
Figure 17: Airgo AP LEDs
Reset
Default
LEDs
Console port
10/100BaseT
Ethernet port
Power connector
A0002B
A0004A