User's Manual

4 Configuring Radio Settings
66 Installation and User Guide: Airgo Access Point
Admin State Configuration
Use the Admin State tab (Figure 43) to assign the mode or persona of each radio interface.
Figure 43: Radio Configuration - Admin State
Set the following parameters on this tab:
Feature Description
Select Radio Interface Select the AP radio (wlan0 or wlan1).
Current Operation State Displays the current operational state of the radio.
Admin State of Selected
Radio
Enable or disable the selected radio. When the AP radio is in the disabled
state, all valid configuration settings are saved. When the AP radio is enabled,
the latest configuration is applied. It is not possible to disable the BP radio by
administrative intervention. Only the AP radio may be disabled.
Current Radio Persona Displays the current mode of operation of the radio.
Persona of Selected
Radio
Select whether the AP radio is to operate as a normal AP (AP) or in backhaul
point mode (BP). Select Any to determine the radio mode automatically based
on network connectivity, configuration, number of radios, and presence of
Ethernet connectivity. It is recommended that you accept the default setting of
Any.