User's Manual

9 Managing the Network
182 Installation and User Guide: Airgo Access Point
• Once the authentication is complete, the AP is enrolled. It is not necessary to enroll the AP
again, even if power is lost to the unit.
An NM Portal can discover up to 50 APs across up to five subnets, and can enroll and manage up to
20 APs. To access the enrollment panel, choose AP Enrollment from the Network Topology
menu. The AP Enrollment panel opens to display the list of discovered, but as yet un-enrolled, APs
(see Figure 129).
Figure 129: Network Topology - AP Enrollment - Not Enrolled
Perform the following functions from this panel:
NOTE: In order to enroll an AP, it must be in the factory default state. This assures that
enrollment will be based on a known configuration.
Function Description
Enroll an AP 1 Select the desired AP, and click Enroll to open the Enroll an AP Entry
panel (Figure 130). If the AP is not in the factory default state, a message is
presented. Click the AP link to open the web interface for the AP and reset
it to the factory default configuration.
2 After verifying the information on the panel (Table 15), enter the correct
password, and click Enroll. It takes a couple of minutes to enroll the AP.
Delete an AP Select an AP and click Delete to remove it from the list.