User's Manual

9 Managing the Network
210 Installation and User Guide: Airgo Access Point
Static IP
Use the Static IP tab (Figure 155) to reserve static IP addresses for specific nodes.
Figure 155: NM Services - DHCP Configuration - Static IP
Enter the following information on this tab:
Click Add to save the information. The new entry is listed in the table at the bottom of the tab. To
delete an entry, select the name in the DHCP Static IP Table, and click Delete.
Managing Network Faults
NM Portal aggregates alarms from all managed APs. Each AP can store up to 260 alarms locally.
When the number of alarms exceeds this limit, the oldest alarms are deleted as needed. Use the
Fault Management panels to view the system alarms and syslog entries. Alarms are raised as SNMP
Traps, which are forwarded to the SNMP Sink Host (or Primary NMS).
Viewing Alarms
Choose Alarm Summary from the Fault Management menu to view counts and descriptions of
alarms that occur in the network managed by NM Portal.
Field Description
Client Fully Qualified
Domain Name
Enter an alphanumeric name for the node, which is fully qualified by
DNS.
Client MAC Address Enter the MAC address that uniquely identifies the client station.
Assigned IP Address/
Maskbits
Assign the static IP address and maskbits.