User's Manual

9 Managing the Network
214 Installation and User Guide: Airgo Access Point
Table 16: Airgo Access Point Alarms
Alarm ID Description
Discovered New Node Generated when a new Airgo Access Point is discovered by
NM Portal for the first time.
Node Deleted from Network Generated when a previously-discovered node is deleted from
the system. When the node is deleted, all information about that
node is deleted from NM Portal. If the node’s IP address falls
within the discovery scope, then the node will be rediscovered
and added back to the set of the discovered nodes during the
next discovery scan.
Managed Nodes Limit Exceeded Generated when the number of discovered nodes exceeds the
limit defined in the Discovery Configuration panel,
Configuration tab. See “Configuring Network Discovery” on
page 200). If this alarm occurs, NM Portal ceases to discover or
track any new nodes.
Node Enrolled Generated when an Airgo AP has been successfully enrolled.
Node Un-Enrolled Generated when an Airgo AP has been successfully rejected
(un-enrolled).
Policy Download Successful Generated when a policy is successfully downloaded to an AP.
Policy Download Failed Generated when policy downloaded to an AP is unsuccessful
due to an error in the policy, software version mismatch, or
another error.
Image Download Succeeded. Generated when an image is successfully downloaded and
applied to an AP.
Image Download Failed Generated when image download to an AP is unsuccessful, due
to corrupted images, images of invalid length, or connectivity
failures.
Software Distribution Succeed Generated when an image distribution is completed.
Radio Enabled (BSS Enabled) Generated when an AP radio is enabled. Indicates successful
start of a BSS and includes the channel on which the AP radio
will be operating.
Radio Disabled (BSS Disabled) Generated when an AP is disabled. Disabling can be user
triggered for administrative purposes, caused by radio reset due
to application of wireless configuration parameters, triggered
by hardware, or due to a change in SSID.
BSS Enabling Failed Generated when an attempt to enable an AP radio fails.
Reason codes:
0 – Unspecified reason
1 – System timeout attempting to enable BSS
Frequency Changed Generated when operating frequency is changed for an AP
radio due to user intervention or events such as periodic
dynamic frequency selection (DFS).
Reason Codes:
0 - Triggered due to DFS
1 - User triggered