User's Manual

Remote Control Preparation

Battery Installation (D)

Install batteries for the remote control as per Figure D.

Service life of batteries

- The batteries normally last for about one year although

this depends on how often and for what operations the

remote control is used.

- If the remote control unit fails to work even when ope-

rated near the player, replace the batteries for a try.

- Use size AAA batteries (2 pieces)

Notes:

- Do not use rechargeable (Ni-Cd) batteries.

- Do not attempt to recharge, short circuit, disassem-

ble, heat the batteries or throw them into the re.

- Do not drop, tramp on or impact the remote control.

This may damage the internal parts or lead to mal-

function.

- Do not mix used and new batteries on the remote

control.

- If the remote control is going to be idle for a long time,

remove the batteries. Otherwise, electrolyte may leak

causing malfunction and even burns if contacted with

human body.

- Wipe away any electrolyte leakage inside the remote

control, and replace with new batteries

- If any electrolyte happens to contact with your body,

wash it off thoroughly with clean water immediately.

Operation range of Remote control (E)

- The normal operation range of the remote control is about 5m and within about 60 degrees in front of the unit.

- The effective distance varies slightly with the brightness of the room.

Notes:

- Do not point bright lights at the remote control sensor

- Do not place any shield between the remote control and the sensor.

- Do not use this remote control while operating the remote controls of any other equipment.