Operation Manual

AIRIS POWER SERVER
User Manual Rev 1.0
45
The System Information displays some useful information about the
system. It shows the firmware version, the system up time and the internal
and external network connections. On SA, We have one WAN port and
four LAN ports. The WAN port belongs to the external network interface
and the LAN port belongs to the internal network interface. They are
described as below:
 Firmware Version: 2.00
 The system up time
 IP Address: the IP address is shown as your current setting.
In Chapter 2, section 2.4, the Basic setting, we already configure the
external interface in one of the three ways, ADSL/PPPoE, DHCP
client and Fixed IP address. In Chapter4, section 4.1, DHCP Server,
we assigned the IP address range to the internal network interface.
 Hardware Address: Ethernet hardware address
 Netmask: corresponding to the network.
 Max. Transfer Unit: maximum bytes of a packet.
 Tx/Err Packets: e.g. 309/0, means you sent 309 packets and there
are “0” packets with errors.
 Rx/Err Packets: e.g. 3573/2, it means you received 3573 packets
and there are 2 error packets.
 Link Status: Shows the current transfer speed. e.g. 100Mbps, full
duplex.
 The refresh button: Click the refresh button to see if anything has
been updated.
If your external connection is not set to a fixed IP address, you can check
whether the Powerful Server appliance has obtained an IP address after
booting. If there is no external IP address, you should check your network
connection or environment settings.