User's Manual

6 EKAHAU T301-A USER GUIDE
3.4 Battery replacement
Batteries are replaced by opening the four screws on the backside of
the tag. Old batteries maybe removed from the device by pulling them
gently upwards. New batteries should be placed between the battery
springs. Check that the orientation of the batteries is correct. There
are battery orientation indicators on the top cover and on the circuit
board. The correct orientation is also showed in the image on the
following page.
Recommendations for choosing and replacing batteries:
y Use always new batteries.
y Replace both batteries at the same time.
y Use only 3.0V, CR2 size batteries.
y Ekahau recommends batteries from Maxell, Sanyo or VARTA.
After batteries have been replaced close the back cover, replace and
tighten the screws.
+