User's Manual

4 Tag configuration
The tag can be adjusted for each application and network settings by adjusting a set of parameters.
The parameters can be changed wirelessly using the Ekahau Activator T301-A laptop software
or through Tag Configurations in EPE.
Ekahau Activator is used for configuring the initial configuration settings that allows connecting
the tag to EPE over the network. After connection is established with EPE all configurations can
be managed through EPE.
4.1 Tag settings in Activator
The list of network settings available in Activator
Default valueValuesDescriptionSetting
Positioning Engine settings
0.0.0.0IP Address.IP Address Ekahau
Positioning Engine.
Engine IP
8552Port numberPort number of location
protocol port of EPE.
Engine Port
0.0.0.0IP AddressIP Address of Ekahau
Positioning Engine, from
where TAG gets the set-
tings. Typically same as
the Engine IP
Maintenance IP
8553Port numberPort number of mainten-
ance protocol port of
EPE
Maintenance port
100 - 63072000The interval of the peri-
odic maintenance calls
in seconds
Maintenance interval
Scan Settings
100 - 63072000The interval of the peri-
odic location scans in
seconds.
Scanning Interval
1 - 11 Enabled; 12 - 14 DisabledEnabled; DisabledSets the channels that
are scanned
Scan Channels
WLAN Settings
defaultSSID=max 32 digitsSets the Wi-Fi network
name -Service set identi-
fier
SSID
No EncryptionNo Encryption; WEP
64/128; WPA2-PSK
Selects if WEP encryp-
tion is used
Encryption
Chapter 4. Tag configuration
17