User's Manual

Default valueValuesDescriptionSetting
-ASCII: 5 or 13 charac-
ters
HEX: 10 or 26 hexa-
decimal numbers (0-f)
Sets the WEP Pass-
phrase
WEP:
11 - 4Sets the WEP index
used
WEP Index:
-8 - 63 ASCII charactersSets the WPA2-PSK
encryption and pass-
phrase
WPA2-PSK:
Not supported in T301-
B
WPA-PSK
IP Settings
DHCPDHCP; StaticDefines the IP address
assigning method.
IP method
Static IP Settings
0.0.0.0
0.0.0.0
IP address.Sets the start and end
address of the range
used to assign the IP
addresses to the tags
when Static IP is used
Address range
0.0.0.0IP addressTag netmask when
static addressing is
used.
Network mask
0.0.0.0IP addressIP network gateway
when static addressing
is used.
IP gateway
4.2 Tag configuration settings in EPE configs page
In Ekahau Positioning Engine it is possible to create configurations to single or multiple tags, after
the tags are activated, the configurations are applied to tags from the Tags page. The list of
available settings is in the following table
Values (Default underlined)DescriptionSetting
General
Free textName for the configuration setName
Free textDescription for the configuration setDescription
Network
seeTag settings in Activ-
ator on page 17 for details
SSID 1 name, Encryption, Pass-
phrase and WEP index.
SSID 1
seeTag settings in Activ-
ator on page 17 for details
SSID 2 name, Encryption, Pass-
phrase and WEP index.
SSID 2
18
Chapter 4. Tag configuration