User's Manual

Values (Default underlined)DescriptionSetting
No Association scan only; Associate
and scan
Sets whether tag attempts to asso-
ciate on T301-B SSID 2 network
SSID 2 Association
1- 11; 12 (EU); 13 (EU); 14 (Japan)Sets the channels scanned during
a location scan
Scan Channels
Enabled; DisabledSets whether the tag uses broad-
cast probe when scanning
Broadcast probe
Tag IP Settings
Use DHCP for each access point
Use DHCP once for all access
points
Preserve the IP-address that was
given by Activator
Sets the IP method usedIP Setting
Positioning Engine
IP AddressSets the EPE IP AddressIP Address
Port numberPort number of location protocol port
of EPE.
Location update Port (UDP)
The interval in Seconds, Minutes,
Hours or Days
The interval of the periodic mainten-
ance calls in seconds
Maintenance interval
Port numberPort number of maintenance pro-
tocol port of EPE
Maintenance port
Periodic location update
Enabled; DisabledEnables or disables the periodic
location update
Periodic Wake up
The interval in Seconds, Minutes,
Hours or Days
Sets the interval for the periodic
location update
Interval
Motion Sensor
Disabled; Enabled with profiles from
1 to 4
Enables and sets the sensitivity for
the motion sensing
Motion Sensitivity
In-motion and after motion; After
motion
Sets whether location updates are
sent periodically during the motion
or just when the motion starts and
after the movement has ended.
Motion Update Method
5s; 10s; 30s; 1min; 2min; 5minSets the interval for motion updatesMotion Update Interval
Tamper sensor
Enabled; DisabledNot used T301-B tagsTamper sensor
Advanced scan settings
Chapter 4. Tag configuration
19