User's Manual

Values (Default underlined)DescriptionSetting
1 - 10Number of scans the tag does on
each triggered scan despite the
triggering event. Used to improve
the accuracy in difficult conditions
and for rarely scanning applications.
Initial Scan Count
No Delay; 250ms; 500ms; 1000ms;
1500ms; 2000ms
Delay between the scans.Delay between initial scans
0 - 10The number of scans the tag per-
forms for each after motion event.
After Motion Scan Count
0 - 10The number of scans the tag per-
forms for each button event.
Button Scan Count
0 - 10The number of scans the tag per-
forms for each tamper event.
Tamper Scan Count
Note
1) Network wide DHCP enables roaming between sub networks. With this setting the tag
refreshes its IP address whenever the tag associates with a new access point. It is not recom-
mended to use the feature, if not required, due to higher power consumption
Note
Using the Advanced Scan Settings need a careful consideration. The scanning consumes a
high amount of energy, and the more scanning is done the less battery life the tag has. Typically
these parameters are used to improve accuracy in very difficult conditions or in cases the tag
otherwise would scan rarely.
4.3 Tag actions available in Ekahau Positioning Engine
Tags properties page
ValuesDescriptionSetting
User Data
Free textA user given name for tagName
Free textA custom noteCustom
List of groups or "No Groups cre-
ated" if no groups exist. Go to
groups page to create groups.
The groups the tag belong toMember of Groups
Commands
20
Chapter 4. Tag configuration