User's Manual

StatusRight LEDLeft LEDAction
After completing the
sequence erases all config-
urations from the tag
memory.
-
1xOrange
1xOrange
1xOrange
Reset. Keep Blue button
down until Right LED
blinks orange, then press
Red button button until
both LEDs blink.
2.4 Button activated location update and maintenance
call
The tag can also be set to scan and update it's location by pressing any of the buttons. After a
button press the tag scans and sends the results to EPE immediately, if Red button was pressed
the TAG will additionally do a maintenance call to update the settings. The LEDs indicate the scan
success or failure similarly as in the scan activated by the wake up interval.
2.5 Safety switch activated location update
If the safety switch is pulled out from it's original position the tag will update it's location to the EPE
with the Safety Switch flag. If the location update is not succesful the tag will retry until the battery
is empty.
Figure 2.2. Safety switch operation.
2.6 Resetting to factory settings
The tag can be reset to factory setting with the following button sequence .
1. Press and hold the Blue button until Right LED flashes orange. When the tag is busy this may
take even 20 seconds.
2. Then immediately press down the Red button .
3. After approximately 2 seconds both LED’s flash orange.
Chapter 2. Tag operation
5