User's Guide

!
19
Chapter 3. Configuration After Initial
Activation
Setting
Description
Values (Default underlined)
Location Beacon Sensor
Enable or disable the location beacon
sensor . In active mode a location
update is done immediately when the
tag notices a location beacon. In
passive mode the recent observed
location beacon ID is sent to EPE
only when location update is initiated
by other stimuli such as periodic or
motion wakeup.
Disabled, Passive Mode, Active
Mode
Advanced Scan Settings
Initial Scan Count
Number of scans the tag does on
each triggered scan despite the
triggering event. Used to improve the
accuracy in difficult conditions and
for rarely scanning applications
1 - 10
Note
1) Network wide DHCP enables roaming between sub-networks. With this setting the tag refreshes
its IP address whenever the tag associates with a new access point. It is not recommended to
use the feature, if not required, due to higher power consumption
Note
2) Using the Advanced Scan Settings need a careful consideration. The scanning consumes
a high amount of energy, and the more scanning is done the less battery life the tag has. Typ-
ically these parameters are used to improve accuracy in very difficult conditions or in cases the
tag otherwise would scan rarely.
3.2 Tag Actions Available in ERC Tags Properties Page
Setting
Description
Values (Default underlined)
User Data
Name
A user given name for tag
Free text
Custom
A custom note
Free text
Member of Groups
The groups the tag belong to
List of groups or "No Groups cre-
ated" if no groups exist. Go to
groups page to create groups.
Commands
Setting