User's Guide

!
Chapter 3. Configuration After Initial
20
Activation
Setting
Description
Values
LED / Vibration
Launches the alarm at the tag with
LEDs only or with vibration and
LEDs. The alarm duration can be
set.
LED; LED and Vibration
Duration: 10s; 1min; 10min; 30min;
1h; 2h
Manual Commands
Manual command or a list of com-
mands can be sent to a tag.
-
Set Config
A pre-defined config can be selected
and sent to tag(s)
A list of available configs. Go to
configs page to create tag configur-
ations.
Firmware Update
Firmware
Tag firmware can be updated. The
new firmware needs to be first
uploaded in the configs page
A list of available firmware updates
uploaded in ERC. The firmware
needs first to be uploaded into ERC,
this is done in configs page.
Create New Group
Group Name
New group is created and the tag is
included into this created group.
Free text
Address
Gateway
Sets the default gateway for the tag
IP Address
Delete
Delete
The tag is deleted from the system.
All statistics are cleared. The tag will
appear in the system again when it
report it's location next time.
-
Note
Note
Currently the W4's vibration is controlled and configured by using the same commands that are
used with the Buzzer. Remember that W4 tag does not have a buzzer alarm!