User's Guide

Chapter 6. Certifications

6 Certifications

6.1 FCC Rules

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) device may not cause harmful interference, and

(2) device must accept any interference received, including interference that may cause

undesired operation.

FCC ID of this device is: TA7-T301-W1

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates uses

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

● Reorient or relocate the receiving antenna

● Increase the separation between the equipment and receiver

● Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected

● Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

6.1.1 Réglementations FCC

Les changements ou modifications non expressément approuvés par Ekahau, Inc. peuvent annuler

votre droit d.utiliser cet appareil aux termes des réglementations FCC.

Cet appareil est conforme à la section 15 des règlements FCC sur les appareils numériques de

classe B.

Fonctionnement soumis aux conditions suivantes :

(1) Cet appareil ne doit pas causer d’interférences nuisibles.

(2) Cet appareil doit accepter toute autre interférence reçue, y compris les interférences susceptibles

d'entraîner un fonctionnement non désiré.

6.2 CE Marking

This device has been tested to meet the Electromagnetic Compatibility (EMC) and User safety

requirements in accordance with following standards: EN55022, EN55024, EN301489-1,

EN301489-17, EN300328, EN62479 and EN60950 for the CE Declaration of Conformity (DoC).