Technical data

RotoFlex

™

II Pump

10 3A1176A

Reassembly

1. Bend hose (23) so colored dots on hose fittings face

each other and slide hose fittings through hose

bracket (27).

NOTE: Make sure protective fabric faces outside of

hose. Roller will touch exposed area of pump hose

when pump is in place.

2. Squeeze hose ends together to keep hose (23) and

bracket (27) together and feed pump hose fittings

through holes on front of base.

3. Use 3/8 in. socket to tighten screw (36) on hose

bracket (27).

4. Install hopper and tighten hopper fitting on hopper

(1) by hand until snug.

5. To set pressure, apply petroleum jelly to threads

(41), tighten knob (41) until back of bracket (25) is

approximately 1/2 in. from front of tensioning

bracket (16).

Tighten front spacer (56) until flush to front of ten-

sioning bracket (16). Tighten back spacer (56) 3/8

in. from tensioning bracket.

NOTE: To break in new pump, run sprayer dry for no

longer than two minutes.

NOTE: Replace hose when mud seeps through slots in

the base and leaves material on the floor.

ti3084a

ti8780a

ti9710a

ti9656a

ti8787a