Instruction manual

6
7
REMOVE SPRAY TIP. ENGAGE
GUN SAFETY LATCH.
FIG. 2
FLUSHING PROCEDURE
WARNING: To reduce the risk of
static sparking which can cause
re or explosion, always hold
a metal part of the gun rmly
against the metal pail when ush-
ing. This also reduces splashing.
Refer to gure 3
HOW TO FLUSH
FIG. 6
HYDRAULIC PRESSURE CONTROL
ASSEMBLY
MAINTAIN FIRM METAL TO METAL CON-
TACT BETWEEN GUN AND CONTAINER
FIG. 5
1. Be sure the gun safety latch is engaged and there is
no spray tip in the gun. Refer to Fig. 2. Refer to your
separate instruction manual provided with your gun on
its safety features and how to engage safety latch.
2. Pour enough clean, compatible solvent into a large,
empty metal pail to ll the pump and hoses.
3. Place the suction tube into the pail or place the pail
under the pump.
4. Turn the pressure control knob to low pressure. Refer to
Fig. 3.
5. Open the prime valve to the open - "Priming Position".
This will allow an easy start. Refer to Fig. 3.
6. Turn the engine ON/OFF switch to ON.
7. Move the choke toward the closed position as per Fig.4.
8. Move the throttle lever slightly to the left as per Fig.4.
9. Turn the fuel valve ON as per Fig. 4. Pull the start rope.
Pull the engine over against compression stroke and
then let the rope rewind slowly into the starter. Pull
rmly and rapidly to start the engine. Do NOT drop the
rope. Hold on to the handle while rewinding, or the rope
may rewind improperly and jam the assembly. If the
engine does not start, open the choke a little more. If the
engine oods, open the choke all the way and continue
cranking.
10. After the engine is warm, gradually close the choke
lever, increase the RPM of engine slightly by moving
throttle to the left. Close the prime valve. Refer to Fig. 3
11. Point the gun into the metal pail and hold a metal part of
the gun rmly against the pail Refer to g.5
12. Disengage the gun safety latch and squeeze the gun
trigger. At the same time, slowly turn the pressure
control knob (Fig. 3) clockwise just enough to move
liquid at low pressure.
13. Allow the pump to operate until clean solvent comes
from the gun.
14. Release the trigger and engage the gun safety latch.
15. If you are going to start spraying, place the pump or
suction tube into the supply container. Release the gun
safety latch and trigger the gun into another empty,
metal container, holding a metal part of the gun rmly
against the metal pail (Fig. 5), forcing the solvent from
the pump and hose. When paint starts coming from gun,
turn pressure control knob to minimum pressure, place
prime valve in prime (open) position and engage the gun
safety latch.
16. If you are going to store the sprayer, remove the suction
tube or pump from the solvent pail force the solvent from
the pump and hose. Engage the gun safety latch and
refer to the "Storage" Procedure on page 5. Step 5.
17. Whenever you shut off the sprayer follow the
PRESSURE RELIEF PROCEDURE warning on page 9.
CHOKE LEVER
FUEL VALVE
THROTTLE LEVER
FIG. 4
PRIME VALVE
CLOSED
(Pressure)
OPEN
(Priming &
Pressure Relief
FIG. 3