Specifications

10
11
SPRAY GUN OPERATION
Reversible
Spray Tip
Tip Guard
Trigger
Guard
MAJOR COMPONENTS OF SPRAY
GUN AND REVERSIBLE SPRAY TIP
SPRAY GUN
Attach spray gun to airless unit and tighten ttings securely.
Set the gun safety latch. (Also may be called gun safety lock,
or trigger lock)
* The gun safety latch should always be set when the gun is
not being triggered.
Read all warnings and safety precautions supplied with the
spray gun and in product manual.
SPRAY TIP ASSEMBLY
1. Be sure pressure relief procedure is followed before
assembling tip and housing to the gun.
2. Lock gun safety latch.
3. Insert REV-TIP™ cylinder into the REV-GUARD™
(guard housing assembly).
4. Guide metal seat into REV-GUARD™ (guard housing
assembly) through retaining nut & turn until it seats
against the cylinder.
5. Insert O-Ring gasket on metal seat so it ts in the grooves.
6. Finger tighten REV-GUARD™ retaining nut onto the gun.
7. Turn guard in the desired position.
8. Completely tighten the retaining nut.
O-Ring Gasket
Metal Seat
REV-TIP™ Cylinder
Retaining Nut
Spray Position Shown
Reverse to
Unplug
REV-GUARD™
Guard Housing Assembly
TO REMOVE CLOGS FROM SPRAY TIP
1. Lock gun safety latch.
2. Turn REV-TIP™ handle 180 degrees.
3. Disengage trigger lock & trigger gun into pail.
4. If the REV-TIP™ handle appears locked (resists
turning), loosen the retaining nut. The handle will
now turn easily.
5. Engage gun safety latch & return handle to the
spray position.
Retaining Nut
CLEANING SPRAY GUN
CLEANING FILTER IN GUN HANDLE
Immediately after the work is nished, ush the gun out with
a solvent. Brush pins with solvent and oil them lightly so
they will not collect dried paint.
To clean the lter, use a brush dipped in an appropri-
ate solvent. Change or clean lters at least once a day.
Some types of latex may require a lter change after
four hours of operation.
Handle
(lter inside)
Gun Safety
Latch or lock
CLOGGED FLAT TIP
Should the spray tip become clogged, relieve pressure from
hose by following the "Pressure Relief Procedure." Secure
gun with the safety latch, take off guard, take out the tip,
soak in appropriate solvent & clean with a brush. (Do not
use a needle or sharp pointed instrument to clean the tip.
The tungsten carbide is brittle and can chip.)
™
™