Specifications

1. New Sprayer
Your Airlessco unit was factory tested in an antifreeze solution which was left in the pump.
Before using oil-base paint, ush with mineral spirits only. Before using water-base paint
ush with soapy water, then do a clean water ush.
2. Changing Colors
Flush with a compatible solvent such as mineral spirits or water.
3. Changing from water-base to oil-base paint
Flush with soapy water, then mineral spirits.
4. Changing from oil-base to water-base paint
Flush with mineral spirits, followed by soapy water, then do a clean water ush.
5. Storage
Oil-base paint: Flush with mineral spirits.
Water-base paint: Flush with water, then mineral spirits and leave the pump, hose and gun
lled with mineral spirits. For longer storage, use mixture of mineral spirits and motor oil
(half & half). Shut off the sprayer, follow Pressure Relief Procedure on page 9 to relieve
pressure and make sure prime valve is left OPEN.
6. Start up after storage
Before using water-base paint, ush with soapy water and then do a clean water ush. When
using oil-base paint, ush out the mineral spirits with the material to be sprayed.
Flushing
IMPORTANT: Read Prior to Using Your Sprayer
7