Specifications
26
27
CLUTCH REPLACEMENT (Continued)
FIG. 26
PARTS LIST FIGURE 26
1 301-231 Cog Belt
2 301-264 Clutch Replacement
3 305-088 Screw
4 100-175 Shoulder Screw
5 100-173 Screw Flanged (4)
6 100-174 Set Screw (2)
7 301-534 Block Tensioner
8 301-208 New Gearbox
9 305-045 Plate
10 305-046 Spacer Tube (4)
I
TEM
N
O.
P
ART
N
O.
D
ESCRIPTION
1
7
6
5
4
3
2
10
9
8
12. Slide cog belt over engine pulley.
BELT TENSIONING
13. Slightly loosen the two horizontal screws (Fig 30,
items 19-22) that connect the top and bottom supports
(Fig 30, items 24 & 25).
14. Evenly tighten set screws (Fig 26, item 6) until
ush with tip of block tensioner (Fig 26, item 7) . Check
tension on cog belt by pressing hard with thumb.
Proper tensioning should allow for approximately 1/8".
If belt is too loose, tighten set screws further.
15. Once belt tension is correct tighten down the four
horizontal screws that go through the gearbox plate
(Fig 30, item 8) and into the back of the gearbox. Also
tighten the two horizontal screws (Fig 30, items 19-20)
that connect the top and bottom supports (Fig 30, items
24 & 25). Reconrm that the belt deection is still 1/8".
15. Reassembly connections, covers and uid pump in
reverse order as described in steps 1-7 of the
"Removing Clutch" instructions.