Specifications

2
1
This gas powered airless sprayer is built tough to take
the day after day high volume demands of painting
contractors and equipment rental companies. The SL
"Slow Stroker" paint pump features a large, severe
duty, slow-stroking stainless steel piston. Airlessco's
patented stationary triple-life packing system allows
external adjusment of upper & lower packings.
This SL6250 airless pumps are "Built to
Perform...Built to Last" using the latest technology
in pump design for smooth operation and low
maintenance.
INTRODUCTION
NO MODIFICATIONS or alterations of any AIRLESSCO Equipment or part is allowed.
Before operating this unit, read and follow all safety warnings and instructions
related to the usage of this equipment on pages 2, 3 & 4. READ, LEARN, and
FOLLOW the Pressure Relief Procedure on Page 10 of this manual.
All Service Procedures to be performed by an Authorized Airlessco Service Center ONLY.
MANUAL NOTATIONS
WARNING - Alerts user to avoid or correct conditions that could cause bodily injury.
CAUTION - Alerts user to avoid or correct conditions that could cause damage to or destruction of equipment.
IMPORTANT - Alerts users to steps or procedures that are essential to proper equipment repair and maintenance.
HANDLE THIS UNIT AS YOU WOULD A LOADED FIREARM!
High pressure spray can cause extremely serious injury.
OBSERVE ALL WARNINGS!
Max. Pressure 3000 psi
Output (FreeFlow) 0.0 gpm
Output (At Pressure) 1.7 gpm
Tip Size 1 gun to 0.041"
2 gun to 0.029
Motor Honda GX160
Weight 136 lbs
AIRLESSCO SL6250
Product Diagrams & Parts Lists
Fluid Pump ...................…................................... 20
Paint System ................................………........... 21
Manifold Filter Assembly .......……...…............... 23
Electrical Control Board ..................................... 24
Prime Valve ........................................................ 28
Clutch Replacement ............................................. 26
Clutch Assembly ................................................... 27
Engine Assembly .................................................. 27
Power Unit ..............……………………………..... 28
Frame Assembly .................................................. 29
Suction Assembly ................................................. 29
Accessories .......................................................... 30