User`s manual

58
Parameter Description
Popular applications You can select a pre-defined application from the list of Popular
applications, and the ID you wish to fill the setting in. Click Copy
to and the setting you selected will be filled into the specific ID.
Trigger Enter an outbound port number assigned by the application.
Incoming Ports When the trigger packet is detected, the inbound packets to the
specified port numbers are allowed to pass through the NAT
firewall, type in a range of incoming ports to be triggered, for
instance, “5000-5300” or “9091, 9093-9100”. It depends on the
special application’s requirement.
Enable Check to enable this Special Application rule.
Note: Only one PC can use each Special Application tunnel at same time.
If the mechanism of Special Applications fails to make an application work, try setting
your computer as the DMZ host instead, please refer to Section 3.2.3 Miscellaneous for
details .
Click Save after you’ve finished all settings.
3.2.3 Miscellaneous
If you have a local client PC that cannot run an Internet application (e.g. Games) properly
from behind the NAT firewall, then you can open the client up to unrestricted two-way
Internet access by defining a DMZ Host. The DMZ function allows you to re-direct all
packets going from your WAN port IP address to a particular IP address in your LAN.
You can configure DMZ in this page, as well as UPnP and other settings.