Network Router User Manual

6
Blinking: Data transmission
Wireless
On: Wireless is ready
Blinking: Data transmission
LAN
On: Link established
Blinking: Data transmission
WPS (WiFi Protected Setup)
Blinking Green: WPS setting in progression
Static Green: WPS successfully set up
Blinking Red: Error found
3. Verifying Connection to the Router
Step 1 Go to Start, Run, type command (for Windows 95/98/ME) or cmd (for Windows
2000/XP) and click OK. You will see the command prompt as below.
Step 2 Type ping 192.168.1.1 and press Enter. You should get four reply responses
back.
Step 3 If you get Request timed out, or Destination host unreachable, double-check
the network cable connection between the computer and the router and try Step 2 again.
If you still encounter problem, go to the next step; otherwise proceed to Section 3,
Configuring the Router.