Fast Ethernet Adapter Quick Installation Guide

1. Insert the Boot ROM into the socket on the

Adapter.

2. Refer to the installation procedures provided

by the network operating system.

Troubleshooting

If you experience any problems with the Adapter,

first verify that the appropriate driver is loaded, that

the proper grade of cable is employed for the

network connection, and that the supporting hub is

functioning properly.

1. Verify that the Adapter is fully and firmly

seated in the slot connector.

2. Check the length and rating of the connecting

cables.

3. Verify that the Adapter's PCI slot is not

deactivated at the BIOS level. The CMOS

Setup utility of the computer ordinarily

provides the option to activate or deactivate

PCI slots.

4. Replace the Adapter in question with a verified

Adapter and run RSET8139.EXE diagnostic

tests from the \DIAG\ folder of the floppy disk.

5. Install the Adapter to another PCI computer

and run the tests again.

Remove all other PCI adapters from the computer

and run the tests again. If the verification/diagnostic