Quick Installation Guide 8-Port 10/100 Mbps Green Switch Model# ASW308 Ver.
Introduction This Quick Installation Guide tells you how to install your 8-Port 10/100 Mbps Green Switch, and how to connect it to your Gigabit Ethernet network. The 8-Port 10/100 Mbps Green Switch is designed for energy saving, easy installation and high performance in an environment where network traffic and the number of users increase continuously. You can add other Ethernet devices like computers, IP cameras, and Network Attached Storage (NAS) onto your network quickly and easily.
Section 1 Hardware Description Front Panel LED Indicators LED Color POWER Green LNK/ACT Green Status Description On The switch is powered on. Off The switch is powered off. On LAN port is connected. Off LAN port is not connected. Flashing Transferring or receiving data. Rear Panel Item Name Description Power Power connector, DC 8V / 0.6A. 1-8 10/100 Mbps LAN ports 1 to 8.
Section 2 Connecting the Switch Note: Operating Environment This switch must be installed and operated within the limits of specified operating temperature (32~1310F) and humidity (10~90% Non-condensing). Do not place objects on top of the unit. Do not obstruct any vents at the sides of the unit. Do not position the unit near any heating source such as heater, radiator, or direct exposure to sun. Prevent entering of water and moisture into the unit. If necessary, use dehumidifier to reduce humidity.
Section 3 Troubleshooting 1. Power LED is not lit • Check if the power adapter is properly connected to the power outlet. Make sure the power jack is firmly plugged into the power socket of the switch. 2. Link/Activity is not lit when connect to 10/100 Mbps device • Check the power switch of the network device attached to the switch; make sure it is turned ON. • Check the network cable; make sure it is properly connected to the switch and the network device.
Section 4 Technical Support E-mail: support@airlink101.com Website: www.airlink101.com *Power savings may vary depending on products used. Actual data throughput will vary. Network conditions and environmental factors lower actual data throughput rate. Specifications are subject to change without notice. All rights reserved. Copyright © 2011 AirLink101®.