Network Card - Wireless Adapter User Manual

ManualsBrandsAirlink101 ManualsPower SupplySUPER G WIRELESS USB 2.0 ADAPTER AWLL4030

Ver. 1A

Package Contents:

• Super G USB 2.0 Adapter

• USB 2.0 Extension Cable

• Installation CD

• Quick Installation Guide

Note: Whenever the Found New Hardware Wizard appears, click Cancel to quit

the wizard and continue with the installation.

Step 1 Insert the Wireless USB Adapter to the computer’s USB port.

Step 2 Insert the Installation CD into the CD drive and wait for the autorun screen

to appear.

Note: If the autorun screen doesn’t appear automatically go to Start, Run, and

type D:\autorun.exe (where D is the letter of your CD drive) and click OK.

Section 1

Installation

Quick Installation Guide

Model # AWLL4030

Super G Wireless USB 2.0 Adapter

The following steps are for Windows 2000/XP. Please refer to the User’s

Manual on the provided CD for Windows 98SE/ME.

For Windows 2000/XP, you must update your USB driver to USB 2.0

For Windows XP you must install Service Pack 2 prior to installing the USB

Adapter.

Step 4 Click Next at the welcome screen.

Step 3 Click Install Driver (Windows 2000/XP).

Summary of content (4 pages)

PAGE 1
Ver. 1A Step 3 Click Install Driver (Windows 2000/XP). Quick Installation Guide Super G Wireless USB 2.0 Adapter Model # AWLL4030 Package Contents: • Super G USB 2.0 Adapter • USB 2.0 Extension Cable • Installation CD • Quick Installation Guide Section 1 Step 4 Click Next at the welcome screen. Installation The following steps are for Windows 2000/XP. Please refer to the User’s Manual on the provided CD for Windows 98SE/ME. For Windows 2000/XP, you must update your USB driver to USB 2.
PAGE 2
Step 5 Click Next to accept the License Agreement. Step 9 Click Next to accept the default Program Folder. Step 6 Verify Install Client Utilities and Driver is selected and click Next. Step 10 Read the notes carefully and click Next. Step 7 Click Yes to acknowledge the need for a reboot after the installation. Step 11 Verify Atheros Client Utlity and Supplicant is selected and click Next. Step 8 Click Next to accept the default Destination Folder. Step 12 Click OK to acknowledge the prompt.
PAGE 3
Section 3 Step 13 Click Continue Anyway at the Windows Logo prompt for the Bootloader Download. (Click Yes for Windows 2000). Section 2 Configure USB Adapter The following steps are for Windows 98SE/ME/2000/XP. If you already have signal strength and valid IP address, you do not need to perform the following steps. Step 1 Start the Atheros Client Utility by double-clicking on it from your desktop. Step 2 If there is no Signal Strength and/or the IP Address is all 0’s, select the Profile Managment tab.
PAGE 4
Step 3 Select the Default profile and click Modify. Step 5 Return to the Current Status tab and verify that you have signal strength and valid IP address. Step 4 Enter the SSID (Network Name) that your wireless router/access point is using in the SSID field and click OK. If your wireless router/access point has encryption enabled, you’ll need to apply the same encryption settings to the Adapter as well.