Manual

AirLive IP-2000VPN User’s Manual
9
4. Power Up
• Power on the Broadband modem.
• Connect the supplied power adapter to the IP-2000VPN and power up. Please note that you should
use only the power adapter provided. Using a different one may cause hardware damage.
5. Check the LEDs
• The Power LED should be ON.
• The Status LED should blink during start up, and then turn Off. If it stays on, there is a hardware
error.
• For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is also ON).
• If a PC is connected to the DMZ port, the DMZ port's Link/Act LED should be ON (provided the PC is
also ON).
• The WAN LED should be ON.
6. Router’s default IP
• The default IP address of router’s LAN port is:
IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
• For Web Management, please configure client PC as DHCP client to obtain IP address from
IP-2000VPN.
• After configuring the computer’s IP properly, please enter the router’s IP address “192.168.1.1” in
Web browser to manage the router, type the proper user name and password to pass the router’s
authentication.
7. User name and password
• User’s name: admin
• Password: airlive