Manual

AirLive IP-2000VPN User’s Manual
25
Data – WAN Port Configuration Screen
Identification
Hostname
Normally, there is no need to change the default name, but if your ISP
requests that you use a particular “Hostname”, enter it here.
Domain name
If your ISP provided a domain name, enter it here. Otherwise, it can be left
blank.
MAC Address
Also called Network Adapter Address or Physical Address. This is a
low-level identifier, as seen from the WAN port.
Normally there is no need to change this, but some ISPs require a
particular value, often that of the PC initially used for Internet access.
You can use the Copy from PC button to copy your PC's address into this
field, the Default button to insert the default value, or enter a value directly.
IP Address
IP Address is assigned
automatically
Also called Dynamic IP Address. This is the default, and the most
common.
Leave this selected if your ISP allocates an IP Address to the IP-2000VPN
upon connection.
Specified
IP Address
Also called Static IP Address. Select this if your ISP has allocated you a
fixed IP Address. If this option is selected, the following data must be
entered.
• IP Address.
The IP Address allocated by the ISP.
• Network Mask (Not required for PPPoE)
This is also supplied by your ISP. It must be compatible with the IP
Address above.
• Gateway IP Address (Not required for PPPoE)
The address of the router or gateway, as supplied by your ISP.
NAT
Enable NAT
NAT (Network Address Translation) is the technology which allows all PCs
on your LAN to share the Internet IP address allocated to the WAN port on
this Router. From the Internet, all PCs appear to have the same IP
address.
For normal operation, this setting must be ENABLED.
Disable NAT Disabling NAT will disable Internet access, unless all PCs have valid
Internet IP addresses.
If you wish to use this device for Routing ONLY (and NOT for Internet
access), then NAT should be disabled.