User Guide

AirLive NVR4 User’s Manual
13
The PC that is connected directly to the NVR (or within the same local area network) should
receive an IP from it. Simply access the NVR from your web browser with its IP address
Again, you should be prompted for the username and password. Enter its default username
“admin” and password “airlive” and then click on ”OK” for accessing the system
◎
Note: After you login into the NVR, your browser will prompt you to install the ActiveX
component. For letting the NVR work properly, please click on the prompted message and
allow the browser to install the ActiveX component.
 2.4 Start to Use the NVR
After accessing the NVR via your browser, you should format your hard disk first. Then you
could open the “Channel Setting” page (Setup  Channel Configuration  Channel Setup)
for further configuring the connection between your NVR and IP camera.
Note: You should be prompted to install another ActiveX component after you open the
“Channel Setting” page. In order to make the search function work properly, please go
ahead and install the ActiveX component.