Manual

32 AirLive WH-5000A User’s Manual
WH-5000A Serials User Guide
5.1 Select Operation Mode
The default operation mode is Client mode. You can select Wireless Access Bridge mode at
System
Configuration – Operation mode .
Click the entry on the left hand navigation panel
for
System Configuration – Operation
Mode . Select the radio of Wireless Bridgin g
and press Apply button. The device will be
reboot and then change the operation mode as
Bridge function.
Note that if you change modes your configuration will be lost.
5.2 Wireless Bridge – General
Click the entry on the left hand navigation panel for Wireless Bridge - General . This directs you to
the
Wireless Access Point – Bridging page.
` Signal strength LED MAC:
Signal strength LED MAC allows you
set up the SS (Signal Strength)
LED to indicate the received bridge
signal strength
(RSSI, Received Signal Strength Indication)
of
remote device the. When you
key in the BSSID at “Add
remote’sAP BSSID/Note”
section and
click “Add”, this BSSID will be indicated
here. Choosing the
BSSID that you want to know the received signal strength, the SS LED will indicate
the signal
strength by different flicker frequency. If you don’t wish to display any connection signal, select “ Not
Assigned ”. You need click “ Apply ” after you change this value.