Manual

8.3.2 Wireless Bridge – Radio GUI Screen

Click the entry on the left hand navigation panel for Wireless Bridge - Radio when bridge mode set as

Auto Bridging, directs you to this page

y MAC Address:

This is the MAC Address for WLAN card that is for bridge fun

ction.

y Wireless M

ode:

WH-9100MESH supports 802.11 b/g Mixed, 802.11g

Super and 802.11a modes

Note:

When the WH-9100MESH’s AP is working, we don’t suggest you set up the bridge’s

Wireless mode as 802.11g Super mode. This is because the 802.11g Supper mode occupy

large frequency bandwidth, it may interfere the AP’s radio signal.

y Tx Rates:

When set to AUTO, the unit attempts to select the opt

imal rate for the channel. If a fixed rate is

used, the unit will only transmit at that rate.

y Chan

nel No:

The channel number is a means of an assigni

ng frequency that device uses it to

transmit/receive data. The channel number should be same as the one using on the devices

those will be bridge together.

y Tx P

wr Mode:

It is same as AP, support Off, Fix and Auto modes. At Fix mode, th

ere are 5 signal levels you

can select (1 being the smallest power level). If you want to prevent any radio frequency

transmission, set Tx Pwr Mode to off.

y Propagation Distance

This parameter relates to adjust the timing of

WLAN MA

C. To make sure the radio signal

can reach to the device at other end, set the

distance based on the distance between this

AirLive WH-9100-MESH User’s Manual