Manual

6. Command Line Interface
AirLive WHA-5500CPE-NT User’s Manual
82
 signal survey <bssid> <channel>
 Purpose : Display continuous RSSI for the remote AP/Bridge
 Example :
Command> signal survey 00-4f-69-52-a1-ed 36
BSSID Channel Signal Strength(dbm)
================================================
00-4F-69-52-A1-ED 36 -40
BSSID Channel Signal Strength(dbm)
================================================
00-4F-69-52-A1-ED 36 -40
…
.
6.2 Debugging Commands
This debugging commands are commands used for manufacturing testing process. If a
z_debug command looks similar to a Set command, please use the Set command instead.
 z_debug http logout
 Purpose : log out HTTP
 Example :
Command> z_debug http logout
 z_debug signature <enable/disable>
 Purpose: Enable or disable signature check on firmware
 Example:
Command> z_debug signature disable
Are you sure ? ( y/n ) : y
Signature check is now DISABLED!!!
 z_debug add ssid <ssid>
 Purpose: This command will replace the default ssid with the new one. It
will not add an additional SSID. We recommend to use the following
commands instead:
 add ssid <ssidname> broadcast (enable/disable) to add a new SSID
 set ssid <ssidname> to replace the current ssid name with a new one