Manual

6. Command Line Interface
83 AirLive WHA-5500CPE-NT User’s Manual
 Example:
Command> z_debug add ssid air1
 z_debug reboot
 Purpose: reboot your WHA-5500CPE-NT
 Example:
Command> z_debug reboot
Rebooting...
 z_debug set port radio1 11a <ssid> <channel>
 Purpose: Set SSID and Channel. We recommend using set commands
instead;
 set ssid <ssid> : to set the ssid name
 set rate mode <mode value>: set radio mode to 11a | supera_no_turbo
| supera_static_turbo.| supera_dynamic_turbo
 Example:
Command> z_debug set port radio1 11a air2 64
6.3 Show Commands
Show Commands are command that show the settings and status of WHA-5500CPE-NT
 show arp table
 Purpose: Show ARP Table
 Example:
Command> show arp table
IP address Flags HWaddress Device
--------------------------------------------------------------------------------------------
192.168.1.100 C 00:1D:60:5E:AE:A0 lan
 show http
 Purpose: Show HTTP service settings
 Example:
Command> show http
HTTP service port: 80
HTTP session timeout: 10 minutes