User`s manual

16 WLA-5200AP v2 User’s Manual
in the network you are located. In other words,
this device will not be visible by any wireless
station.
Band
Choose a mode from the pull-down list.
• 11b/g mixed: Select to allow both
wireless-b and wireless-g devices on
the network.
• 11B only: Select to allow only wireless-
B devices on the network.
• 11G only: Select to allow only wireless-
G devices on the network.
• 11A (indoor): Select to allow only
wireless-A devices on the indoor
network.
• 11A (outdoor): Select to allow only
wireless-G devices on the network.
• 11A (indoor): Select to allow only
wireless-A devices on the outdoor
network.
SSID
The SSID differentiates one WLAN from another;
therefore, all access points and all devices
attempting to connect to a specific WLAN must
use the same SSID. It is case-sensitive and
must not exceed 32 characters. A device will not
be permitted to join the BSS unless it can
provide the unique SSID. An SSID is also
referred to as a network name because
essentially it is a name that identifies a wireless
network.
Channel Number
Allow user to set the channel manually or
automatically.
If set channel manually, just select the channel
you want to specify.
If “Auto” is selected, user can set the channel
range to have Wireless Access Point
automatically survey and choose the channel
with best situation for communication.
The number of channels supported depends on
the region of this Access Point. All stations
communicating with the Access Point must use
the same channel.
Apply Changes
Press to save the new settings on the
screen.
Reset
Press to discard the data you have
entered since last time you press
Apply Change.