User Manual

assign “IP Address”, “Subnet Mask” and “Gateway” for the
print server.
You can enable/disable or set auto for the print server’s
DHCP server. The DHCP server is disabled by default. If
the DHCP Server is enabled or set Auto, you have to assign
a range of IP addresses here. Fill in the “Start IP”, “Range”,
“DNS”, “Subnet Mask” and “Gateway”, and the print server
will assign a unique IP for each client. Note that when
“Auto” is selected, the DHCP Server of the print server will
be enabled only when there is no other DHCP Server within
the network.
8.4.4 SMB
You can enable/disable the SMB protocol from here. If
SMB is enabled, enter the “SMB Group Name” to specify
the SMB group that this print server belongs to. All PC
should join the same group before they can use this print
server by SMB protocol.
107 AirLive WP-201G User’s Manual