User Manual

Note that before you upgrade the firmware please make
sure that the IP Address settings of the print server are in
the same network as your computer.
Load Default: If you want to reset the Print Server to
default factory settings, please click “Load Default”.
Wireless Function: You can select “Auto”, Enable” or
“Disable” to manually configure the wireless function.
y Auto – “Auto” is the default setting of the print server. At this
mode, the print server will automatically decide to enable or
disable the wireless function. When the print server starts up, it
will auto-detect if the LAN port is connected to an active
network by an Ethernet cable. If this is the case, the print
server will run in Ethernet mode. If the print server is not
connected to an active network by Ethernet cable, the print
server will run in wireless LAN mode.
Users can plug the Ethernet cable to the print server at the first,
after configuring the print server features and wireless settings;
they can unplug the Ethernet cable to enable the wireless
connection. It makes the configuration much easier without
creating the wireless connection in advance.
Note: After you have set the wireless function, please remove
the Ethernet cable and then re-plug the power jack of the print
server to activate the wireless connection.
y Enable – Enable wireless function only, the print server’s
wireless LAN will be always enabled and Ethernet will be
always disabled.
68 AirLive WP-201G User’s Manual