Assembly Instructions

OPT1-M-104 Rev.01 Optimus-1 EX - FTS Mast Assembly Procedure
Page 12 of 33
3.4 Mounting the Antennas on the Mast
 To mount the antennas on the upper mast, do the following:
1. Connect the Main antenna bracket to the V-bracket that’s located below the
camera/whether station V-bracket (see Figure 4).
Figure 4 Connecting the V-bracket sub-assemblies to the mast
NOTE:
Before proceeding to the next stage of the FTS assembly procedure, raise the second section
of the mast by a height of 80 cm (just below the point where it reaches its locking position).